Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,105 Posts
Discussion Starter · #1 ·
Hi Guys! Its been a while since TANDEMKROSS has circled back around to do some Kel-tec parts, but we have started to re-focus on their guns and we just released a basepad that will work for both the PMR and CMR. I would love your feedback!

Jake-
 

Attachments

·
Registered
Joined
·
118 Posts
Looks good! Here's another idea:

I just read yet another thread about accidental release of the magazine due to the latch position on the bottom of the mag well. Perhaps a version of the floor plate could be made so that a secondary motion was necessary to activate the magazine latch. Something like a rotating cam that disables the latch until the cam is rotated out of the way would work.

Right now I stick an Accu-wedge in the space between the magazine and the latch if I am anywhere other than the range.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top