Community for Kel-Tec Shooters banner
1 - 2 of 2 Posts

898 Posts
Discussion Starter · #1 ·

Some time back I ordered 2 new hammer blocks, one for my J2Rxx and one for my JPMxx. I tested as posted on KTOG about how to check trigger for short stroke. Did it for my J2Rxx just to see what folks were talking about but did not try on JPM. Ordered two from Kel-Tec because it was posted that new hammer blocks weren't showing up until something like JRxxxx. Well after upgrading my J2Rxx I checked for the short stroke on my JPMxx and low and behold it appears to have the newer hammer block. Don't have to rack the slide, just simply let the trigger out all the way and the trigger resets. What's up with that?

Take care...
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.