Community for Kel-Tec Shooters banner
1 - 6 of 6 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
Just wondering how strict they are about plating the slide. If I have my slide done by Jack and have a cracked slide down the road will they refuse to replace it because of the work I had done to it?
 

·
Registered
Joined
·
8,990 Posts
You will just get a blued slide but yes they will replace it. If you get REAL lucky they may think it's a hard chromed slide and replace with that but probably not. I have learned that they can take the serial number and tell not only when it was made but what configuration it was when they produced it.
 

·
Registered
Joined
·
2,331 Posts
Only course if the slide needs to be replaced for some reason. I'm sure they would make every effort to avoid it if you had aftermarket plating.

Jack Fuselier is well-known to Kel-Tec.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top