Community for Kel-Tec Shooters banner
1 - 2 of 9 Posts

· Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Last night I took my P3AT apart to clean it. In the owners manual that came with the gun it said to lay the gun down and pop out the disassembly pin which I did with tape covered flat screwdriver. Then to move the slide forward off the frame, but to be careful as the "ejector" would now fall out.
I did this, but nothing fell out. I cleaned and lubed the thing.

When I was re-assembling it the slide did not want to go on then I read the part about making sure that the recoil rod/spring assembly and barrel being perfectly centered on the slide. Then everyting went together OK.

After I check functionality with some snap caps and everything seems to OK. This part about the "ejector" has me puzzled? Is that something with older versions of this gun and the manual has not been up dated?

Inquiring minds want to Know??
 

· Registered
Joined
·
29 Posts
Discussion Starter · #5 ·
Thanks for all the replies!! I thought for awhile there I had done something wrong in disassembly/reassembly.

This gun is fairly new and only has a little over 100 rounds through it.
 
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top