Community for Kel-Tec Shooters banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
I own a first generation P3-AT. Sometimes the disassembly pin starts to work its way out of the frame while shooting. Has anyone else had this problem? Any ideas of a fix other than sending back to the factory?
 

·
Registered
Joined
·
1,375 Posts
first check that spring is engaging, if it is ok, then i would call kt SEVERICE and get a new pin...the shoulder may not have enough ridge to hold...you could try a fine hack saw blade to deepen a notch just under the pin head...gpr
 
G

·
As gpr suggested, try a new pin. If that does not do it, ct a notch where the spring will set into the pin, the flatten the bottom of the pin head to indicate the bottom.

Dang... search is slow......I am searching now, if I don't get a hit and repost, then you try the search feature.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top