Community for Kel-Tec Shooters banner
1 - 1 of 1 Posts

· Registered
379 Posts

I just bought one this week for my new P3AT and installed mine pretty much just as you described. Did you notice the two plastic parts "snapping" together near the trigger guard prior to inserting the screws? I took mine off last night to clean the pistol after shooting it and mine was still very tightly held together even after removing the screws and I had to gently pry the two pieces apart. Look at it closely when you take it apart and see if the two are dovetailing together, there is a tab on one that seems to fit in and under the second piece. My description probably isn't a good word picture, but if you look at them closely you'll see what I mean. That might be part of the problem if those two aren't properly joined before you start threading the screws in.

Once you get it mounted and clean the lens, let us know what you find.

Good luck!

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.