[dh440]

Does anyone know if the metal rear sight for the SCCY cpx-2 will be a exact fit for the P11?

 

[GoesBang]

They fit fine.

 

[buzzsaw]

I tried to get one some months ago, but they asked for my serial number. I told them "I didn't have the pistol or SN handy" (truth: I don't own one), so I gracefully ended the call telling them I'd get back with them later. I assume they have caught on to what some of us have done.

I ended up buying some metal sights from someone on ebay, but they lack dimples for paint dots, and they look like they would snag on stuff when you draw it.

For some reason, I couldn't get a new factory rear sight to go into the dovetail in my P-11 slide, and the factory sight that came with it moves around way too easily. It's like the dovetail is too tight, and someone filed down the existing rear sight to get it installed. I bought this gun new, but had the slide refinished. The ebay sight fits and stays put because of its set screw, but has the issues mentioned above. I might try my hand at drilling some dimples, and turn it around so that the surface toward the rear is sloped and less likely to snag. This would also allow the rear sight to be used to rack the slide on the edge of a table, or a belt loop. I understand that this could be a desirable feature in certain circumstances.

Maybe I do have it on backwards. I'll have to check this out.

buzzsaw

 

[dh440]

Thanks for the info, I just put mine on and it's way better then the cheap plastic KelTec sight

 

[Nod]

A couple of years ago I called SCCY and asked them if I could buy the metal rear sight and the gal says "Send me $10 and I'll send it" so I did and she sent me 2 of them. They fit perfect. BUT - it's very easy to drill & tap the KT plastic sight and put an allen screw in it, did that on another P11 and it worked just fine.

 

[dh440]

Me too it was very easy, I used heat from a blow dryer and it tapped out really easy with a hammer, the SCCY sight is way better.

 

[HatRon56]

Does any one know if a Glock rear sight will fit a P-11 ?

 

[Steve912]

Me too it was very easy, I used heat from a blow dryer and it tapped out really easy with a hammer, the SCCY sight is way better.

Is the SCCY taller than K-T by chance? Give ya a higher POI?

 

[dh440]

No it's the same, there the same size. I thought I needed taller sights to until I realized I was jerking that heavy trigger at the last second, I would recommend getting a trigger shoe and snap caps and practice trigger control. Now my accuracy is right on.