[rob17]

I cannot get the elevation to zero in at 25 yards. Ive cranked the front sight post clockwise all the way down as far as it will go, and I'm still shooting half an inch low at 25 yards. Has anyone else had this problem?

 

[Wakefieldad]

Can you file the sight post down?

 

[gbdeamer]

I cannot get the elevation to zero in at 25 yards. Ive cranked the front sight post clockwise all the way down as far as it will go, and I'm still shooting half an inch low at 25 yards. Has anyone else had this problem?

I had a similar problem. Cranked the front post all the way down until there was just a little nub showing and it was still low.

I had another issue with the rifle so I sent it back to Kel Tec. When they returned it the elevation was a bit better, but still not great.

I compensate for it when aiming and I added an offset red dot, so I don't really mind.

Still one of my favorite plinkers...

 

[rob17]

I had a similar problem. Cranked the front post all the way down until there was just a little nub showing and it was still low.

Just how far can you crank it down? Mine seems to bottom out with 3 - 4 mm of height. However neither of my two front sight tools seem to be able to rotate it further; it seems to have bottomed out.

 

[Steve912]

Have you got any unusual burnishing/compression mark on breech face, around 12:00?

 

[sub2kvol]

Mine had this issue. The screw on top of the sight was loose, needed to tighted it up. Keltec says not to touch the screw but this was the issue.

 

[Sub2kFan]

Also, check to ensure your rear sight is fully raised. I started having this same problem, and realized that my rear sight was not fully raised. Just a shot you are having the same issue.