Community for Kel-Tec Shooters banner
1 - 3 of 3 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
Well i finally got around to ordering the parts that should fix my fte problems (this thread:http://www.ktog.org/cgi-bin/yabb/YaBB.cgi?board=104;action=display;num=1158584044;start=7#7)
Yes i procrastinated... lol anyways

I have a new extractor, extractor spring and extractor pin to replace. I have a 1st gen P3AT.
Whats the best / proper way to swap that stuff out? Whats the best tool to get at the pin with?
Looks like i just punch out the pin from the slide but i dont want to start hitting stuff if im not sure. lol
 

·
Registered
Joined
·
2,818 Posts
http://www.1bad69.com/keltec/disassembly.htm
Scroll down till you find the extractor portion.

Or you could modify the instruction some.
With the slide upside down TRY to drive the pin only far enough to remove the extractor. Install the new extractor use the punch to keep the new extractor lined up with the hole. Turn the slide over and tap the pin in from the top side. Some times trying to get the roll pin started back into the hole is the hardest part. If you have a hard time doing this use a pair of needle nose plier to squeeze it together while you start it in the hole.

This is a guess but I think the pin should be 3/32nd.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top