Community for Kel-Tec Shooters banner

1 - 5 of 5 Posts

·
Registered
Joined
·
493 Posts
Discussion Starter #1
I'm in process of building a Shuty/Gluty MP1.

Glock barrel fitted, and the hard part, the AR-style 9mm Glock compatible lower, and the massive blowback upper are done.

My Chicom Anet A6 is an absolute beast. A glutton for punishment... For $195 I can't believe it performs this well.

 

·
Registered
Joined
·
425 Posts
Very cool! :D
 

·
Registered
Joined
·
493 Posts
Discussion Starter #4
(in Darth Vader voice) "Impressive"
Are you the member who printed the 1911 also?
Nope. Other than some single-shot .22 LR stuff this is my first.

And again, not my designs, just the files from the FOSSCAD/DEFCAD "mega pack" .zip file download.

Currently printing the bolt carrier. It's going to be about 17 hours...
 

·
Registered
Joined
·
3 Posts
Hello everyone. I need help choosing a cartridge. My colleagues gave me a printer for my birthday. Only without the cartridge. So I decided to buy a cartridge on https://www.mrdepot.ca/collections/brother-toner-cartridges. Only there was a problem. I don't know which cartridge will fit my printer. I have a matrix printer. When I asked my colleagues what kind of cartridge I needed for my printer, they said any. But I remember reading somewhere that if you pick up the wrong cartridge, you can ruin the printer. So which cartridge will fit my printer?
 
1 - 5 of 5 Posts
Top