Community for Kel-Tec Shooters banner

sub-2000

  1. Sub9 and Sub2000 Rifles
    After reading several posts about recoil and the need for a pad, I fabricated one from 1/2-inch industrial floor pad. This is a fairly stiff foam that you can walk on. I traced the buttstock pattern out on the foam allowing for the folded front sight and cut it out with an exacto knife. I...
  2. Sub9 and Sub2000 Rifles
    Brand new gun. I have the following problems: 1) My front sight post had to be moved 90% to the left side to be on at 17 yards--it wasn't THAT bad until I started trying to shoot steel plates for speed, and then it was annoying. 2) IF I slap my 17rd or 33rd mags in my Gen2 G19 SUB-2K, the...
  3. Sub9 and Sub2000 Rifles
    Anyone know the screw sizes for the Gen 2 Sub2k? I want to replace the receiver and forend screws. Can't find the size or thread pitch anywhere.
  4. Sub9 and Sub2000 Rifles
    I am having feeding problems using the 30rnd Glock .40cal mags in my gen 2 sub2k. It keeps trying to feed a round before the spent case is ejected. The Glock factory 23rnd mag have been working fine. Should I try a new ets mag or just stick with the factory? (I like the extra 7 rounds).
  5. Fluff & Buff / TecWerks
    I shot my sub 2k for the firt time last night. maybe 70 rounds or so. but i noticed the brass was scratched on the side halfway through. I tested it again today without shooting, and fresh ones loaded up then extracted, came out a bit scratched up HORIZONTALLY. not sure whats causing that? I...
  6. Sub9 and Sub2000 Rifles
    I know that I'm not alone thinking Blue furniture would look outstanding on this NiB S2K. Who can help me find Gen II Blue furniture ??
  7. Sub9 and Sub2000 Rifles
    I was able run two 'happy sticks' worth of 9mm through my Gen II this evening. One stick was filled with 115 gr. Winchester White Box, the other was filled with 124 gr. American Eagle. I am happy to report nothing but good news, NO failures, NO problems, NO issues, just flawless fun :D This...
Top